User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
8-38 N_SIGHT R900 User’s Manual for the Neptune Handheld System
1 Select 2 or 1 for Stop
Bits.
2 Select 1 or 16 for Clock
Divisor.
3 Tou
ch or the
Cus_FMT2 tab.
The Cus_FMT2 screen
appears as illustrated in
Figu
re 8.36.
Figure 8.36 Custom Format 2 Screen
4 Type an alphanumeric character in Character, if applicable.
5 From the selection list of Tokens, touch the toke
n you want to add
to the custom format.
6 Touch .
The token you selected now appears in the Use
r Selected list.
7 Repeat steps 5 and 6 to add more characters and tokens
.
8 If there is a
character or token in the User Selected list that you no
longer need,
touch .
The item is removed from the User Selected list.
9 Touch twice to return to the NewFMT screen.
For a list of tokens and their explanations, refer to Appendix B,Chapter ,
"Tokens List for Custom Format Screen" on page -1.
Pilot Release