User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
N_SIGHT R900 User’s Manual for the Neptune Handheld System 8-41
4 Do one of the following:
• Touch Close to close the gas configuration screen and return to
the previous screen.
• Tou
ch SelectFMT to select a format that is already available
for the Field Progr
ammer.
• Touch NewFMT to create a new format and add it to the list
of
available formats.
Selecting a Gas Format
This feature allows an administrator to select formats that will be
available to field personnel for programming, as described in
“Programming the R900G Endpoint,” on page 8-18
To select a format for programming an R900
G endpoint, comp
lete the
following steps.
1 Select Conf
igure Gas from the Field Pr
ogrammer Menu. See
“Starting Field Programmer,” on page 7-4.
2 When prompted, type
your password and press
Enter. See Figure 8.37
The Gas Preferences
screen appears as
illustrated in Figure 7.15.
3 T
ouch NewFMT.
The New Format screen
appears as illustrated in
Figu
re 8.38.
Figure 8.38 Gas New Format Screen
4 Touch .
Pilot Release