User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
Notes:
8-44 N_SIGHT R900 User’s Manual for the Neptune Handheld System
After you select a
format, all the values
associated with it appear
as shown in Figu
re 8.40.
You can then make any
necessary changes.
Figure 8.40 Gas Values Shown on
New Format Screen
5 Touch or click in MULTIPLIER to select the correct value
from 0.01 to 1000 to be use for the format.
6 Type a value for INPUT to enter the input
rate. This is controlled
by the index.
7 Type the 9-digit number for the Pressure Configuration
Factor
index in PCF.
Refer to the listing of PCF indexes, refer to “Pressure Configuration
Factor Indexes,” in Appendix C.These are examples only. This list
does not i
nclude every index a utility has in its system. If there are
any questions
about the correct pressure configuration factor,
contact the meter manufacturer.
8 Touch in DispDig
its to select one o
f the following:
• 4 = Initial Reading will be in range of 0000 - 9999
• 5 = Initial Reading will be in range of 00000 - 99999
• 6 = Initial Reading will be in range of 000000 - 999999
Pilot Release