User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Maintaining and Repairing the Neptune Handheld System
N_SIGHT R900 User’s Manual for the Neptune Handheld System 9-3
To prepare the CE5320 for use after long-term storage, use one of the
following methods:
• Ty
pical method—to ensure that the battery is fully char
ged, allow
the CE5320 to recharge at least 24 hours.
• Quick metho
d—if your
company routinely recharges the CE5320
each business day, allow the CE5320 to recharge for 12 hours.
Checking the Battery Status
To check the status of the battery, place the CE5320 in a communication
cradle. Then, check the battery indicator in the
bottom-right corner of the unit, shown in Figure 9.1, and refer to
the following list.
Figure 9.1 Battery Status Indicator on CE5320
• Red—the battery is low and is charging.
• Green—the battery is fully char
ged.
• Yellow—the temperature of
the battery is too high or too low to be
recharged. When this occurs, the charging system is disabled. The
battery can be recharged when it reaches a temperature of 0ºC to
45ºC (32ºF to 113ºF).
• No color—the
charging device (communication cradle) is
not
receiving power.
battery status indicator
Pilot Release