User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Maintaining and Repairing the Neptune Handheld System
9-8 N_SIGHT R900 User’s Manual for the Neptune Handheld System
6 Press 5 or touch Config
Battery.
The Calibrate Battery
screen appears.
Figure 9.5 N_SIGHT R900 Calibrate Battery Screen
7 Press Y or touch Yes .
8 Type your password when prompted.
The battery calibration begins and will take approximately 24 hours
to complete
.
After the battery has been calibrated, the battery status indicator blinks a
red light
when the battery level is depleted to 10% of its full capacity.
This means that if a battery lasts for 15 hours on full charge, the
indicator light begins blinking 90 minutes before Low Battery
Warning appears and the handheld runs out of battery power.
This feature can be used by meter readers
in the field to warn them
ahead of the final message that appears on the dis
play.
Neptune recommends calibrating the battery if the battery is deeply
discharged, if it is replaced with a new battery, or once every three months.
Pilot Release