User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Maintaining and Repairing the Neptune Handheld System
N_SIGHT R900 User’s Manual for the Neptune Handheld System 9-13
Figure 9.10 Opening the Velcro Closure
Replacing
To replace the existing strap or to install a new one, use the following
procedure.
1 Fold the slotted end of the handstrap back to form a hinge and
loosely secure the V
elcro closure.
2 H
old the door of the battery compartment so that the screws face
you. Then, push the slo
tted ends of the handstrap through the two
holes on the door.
3 Turn the door over so that the inside of the door is facing you, and
slide the sm
all metal pin that you removed earlier through the slots
of the handstrap. If you have difficulty inserting the pin, try loosen-
ing the Velcro tab and pushing more of the handstrap through the
hol
es on the door.
4
Fold the protective foam flap over the battery and replace the door
of the battery compartment.
5 Secure the door of the battery comp
artment to the back panel of the
CE5320 by turning each of the four captive screws cloc
kwise until
you feel some resistance.
Pilot Release