User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Appendix A: Changing Volume Settings
A-4 N_SIGHT R900 User’s Manual for the Neptune Handheld System
7 Scroll to and touch this icon.
The Volume & Sounds
Properties screen appears
as illustrated i
n Figure
A.7.
Figure A.7 Volume & Sounds Properties Screen
8On the Volume tab, enable sounds for the following:
• Events (warnings, system events)
• Applications
• Notifications (alarms, reminders)
• Key clicks: (then select soft or loud)
- Soft
- Loud
• Screen taps: (then select soft or loud)
- Soft
- Loud
9 Move the scroll bar to the appropriate volume level, soft or loud.
As you move the scroll bar, you can hear the volume level you
select.
10 Touch OK.
On this screen you are enabling the volume level of the key clicks and screen
tabs to be loud or soft. To turn key clicks on or off in N_SIGHT R900, refer to
“Turning Key Clicks On and Off,” on page A-24 or“Turning Key Clicks On and
Off,” on page A-27.
Pilot Release