User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Overview of the Neptune Handheld System
N_SIGHT R900 User’s Manual for the Neptune Handheld System 2-15
Figure 2.7 Message Screens
Menu Screens
Menu screens typically display a list of options within a box and prompt
you to select one. To select an option from a menu screen, do one of the
following:
• From the keypad, press the key whose number corresponds to the
ite
m that you want to select. For exam
ple, if the menu displays a list
of trouble codes and the code that you want to select is number 3 in
the list, then press the
THREE key on the keyboard or keypad.
Your selection appears in the display.
•Use the
UP or DOWN key to move up or down the list
until the item that you want is highlighted.
Then press the
ENTER key on the CE5320 or the ENTER
key or on the Nomad. Your selection appears in the
display. You can also use the
TAB or to move forward,
and the
SHIFT + TAB to move backward.
Message screens display information or prompt you to make a
selection. They also can tell you how to exit the current screen or how
to access other screens.
ENTER
Pilot Release