User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
N_SIGHT R900 User’s Manual for the Neptune Handheld System 3-23
1 On any reading
entry screen, press
.
The Properties
screen appear as
illustrated in
Figure 3.14.
Figure 3.14 Handheld Properties Screen
2 Do one or both of the following:
• Proceed to “Changing the Reading Entry Direction,” in the
next s
ection.
• Change the “Changing the Route Read Direction,” on page
3-24.
Changing the Reading Entry Direction
As you enter a reading in the handheld, each number can be displayed
from right to left or from left to right.
3In the Read Dir field, touch th
e down arrow and do one of the
following:
• Select LEFT TO RIGHT if you
want the number to begin
from the left.
• Select RIGHT TO LEFT if you want
the number to begin
from the right.
These setting toggle between Left to Right or Right to Left
according to the current setting.
P
%
This procedure affects only accounts whose directions have not been set by
the host computer. If the reading-entry direction of an account has been set
by the host computer, the host setting replaces your setting.
Pilot Release