User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
3-30 N_SIGHT R900 User’s Manual for the Neptune Handheld System
For assistance in using
the CE5320 to collect
meter readings, refer to
“Gathering Route
Data,” on page 6-1.
Figure 3.24 N_SIGHT R900 Reading Entry Screen
Logging Out of N_SIGHT R900
The only time that you need to log out of N_SIGHT R900 on the
handheld is just before you begin exchanging information with the host
computer. Logging out gives you access to the communication features
of the handheld. Instructions for logging out on the handheld are
included in the procedures that describe how to exchange information
with the host computer. For more information, see “Exiting the
Software,” on page 7-1.
If you allow the handheld to remain inactive for the factory-set delay of
45 secon
ds or for the delay time specified by the host computer
, it turns
off automatically. After this period of inactivity, the screen of the
handheld goes blank and the unit turns off to conserve the battery.
Pilot Release