User Manual
Table Of Contents
8 CMIU Installation and Maintenance Guide
4 Wall Installation
This chapter provides instructions for installing the CMIU.
Installing the Cellular MIU
Removing the Main Housing
Complete the following steps to install the wall MIU.
1 Remove the main housing from the mounting adapter.
Figure 7 Wall MIU Main Housing
2 StudyFigure 8 and the location requirements, then decide how to install the MIU and
mount the adapter with set screw positioned at bottom.
• The cable enters through the bottom or rear cable entry of the mounting adapter.
• When the MIU replaces a receptacle, use the appropriate holes to allow reuse of
the receptacle’s original mounting holes. SeeFigure 8.
• When mounting the MIU to a pipe, use the bolt hole for pipe mounting to bolt the
mounting adapter to a pipe clamp.
Figure 8 Mounting Adapter
The Hi-Lo fastener for securing the main MIU housing
to the adapter plate is shipped separately.
Set screw
A variety of holes in the mounting adapter allows for a
quick and easy installation.
Cable entry
Pipe clamp
Cable exit notch