Maintenance Guide

1. Make sure the flat washer is properly seated, and then connect the black plastic cable
connector housing to the three-lobed plastic latch plate.
2. Tighten the connector by making a 1/4 turn to the right.
Figure 33 – Tightening Connector and Latch Plate
3. Slide the black cone-shaped gasket down the cable until it seats against the connector
housing.
4. Slide the black plastic female-threaded connector down the coaxial cable.
Figure 34 – Cone-Shaped Gasket and Connector
5. Seat on top of cone-shaped rubber gasket and thread onto the three-lobed plastic latch
plate
6. Finger tighten the connector to depress the cone-shaped rubber gasket. This seals the
coaxial cable from moisture intrusion.
28 Cellular MIU (CMIU™) Pit and Wall Installation and Maintenance Guide
Chapter 5: Pit Installation