Maintenance Guide
Table Of Contents
Connecting the Splice Tube
To finish installing the Scotchloks, complete the following steps to install the connector king
splice tube.
1. Take all three connected Scotchloks and push them into the splice tube until fully
encapsulated by the silicone grease.
Figure 41 – Splice Tube
2. Separate each gray wire and place them in the slots on each side.
Figure 42 – Gray Wires in Slots
3. Snap the cover closed to finish the installation.
32 Cellular MIU (CMIU™) Pit and Wall Installation and Maintenance Guide
Chapter 5: Pit Installation