User Manual

Installing the Scotchloks
Complete the following steps to install the Scotchloks.
Figure 22 – Scotchloks Connector
1. Complete steps outlined in "L900 MIU Pit Installation"
on page15 to install the L900 MIU through the lid.
2. Use 3MScotchloks type UR connector to connect the
L900 MIU wires to the encoder wires.
3. Hold the Scotchloks connector between the index
finger and thumb with the red cap facing down. See
Figure 22.
Figure 23 – Color Code for Wires
4. Pair the wires according to the color diagram. See Figure
23.
Figure 24 – Seating Connector Wires
5. Take a non-stripped black wire from the pigtail and a
non-stripped black wire from the L900 MIU and insert
wires into the Scotchloks connector until fully seated
in the connector. See Figure 24.
L900 MIU Pit Installation and Maintenance Guide 19
Chapter 4: Pit Installation