User's Manual

Maintenance and Troubleshooting
32 R900 Wall and Pit MIU Installation and Maintenance Guide
5 Snap the battery casing into the receiving clips on the main
housing. See
Figure 44.
Figure 44 Returning Spliced Battery to Main Housing
6 Reactivate the MIU as shown in Figure 20 on page 16. For help
with this procedure, refer to “Tying the Cable and Activiating
the MIU” on page 16.
Replacing the Transmitter Cover
1 Secure the transmitter cover using the two Phillips head
screws, until the cover is snug and fully seated.
2 Replace the pit lid.
3 Test the installation using the procedure in “Testing the Instal-
lation” on page 21.
Be careful not to pinch the battery wires between
the cover and the housing.