User's Manual

9 If Continuous Leak is repaired
If a continuous leak is found and repaired, complete the following steps:
1 Use no water for at least 15 minutes.
2 Check the leak icon.
3 If the leak is OFF, then a leak is no longer indicated.
10 If Intermittent Leak is repaired
If an intermittent leak is found and repaired, complete the following steps:
1 Check the leak icon after at least 24 hours.
2 If the leak has been correctly repaired, the leak icon changes from Continuous ON to Flashing.
11 Software
A software update is required for EZRoute or RouteMAPS to interpret the advanced feature data
communicated from the Neptune E-Coder)R900.
12 Basement Version Installations
This section describes storage and unpacking instructions, preliminary tests, tools, materials, site
selection, and installation of the E-Coder)R900 Basement version MIU.
Prior to Installation
Storage
Upon receipt, inspect shipping containers for damage, and inspect the contents of any damaged cartons
prior to storage. Once the inspection is complete, store the cartons in a clean, dry environment. Keep in
mind that the Integrated E-Coder R900 MIU has an external battery attached. Storage for more than one
year may affect product life. Be sure to use a first-in first-out inventory control system. See
“Environmental Conditions” on page 4. The unit should not be transmitting until the box is opened and the
unit is exposed to a light source.
Unpacking
As with all precision electronic instruments, the Integrated E-Coder R900 MIU should be handled
carefully; however, no additional special handling is required. After unpacking the Integrated E-Coder
R900 MIU, inspect it for damage. If the unit appears to be damaged or proves to be defective upon
installation, notify your Neptune Sales Representative. If one or more items require reshipment, use the
original cardboard box and packing material.
Figure E-Coder)R900 Basement Version
Tools and Materials
Tables 1 and 2 on page 6 show the recommended tools and materials you may need to successfully
install the Integrated E-Coder R900 MIU or to replace the MIU’s external battery pack assembly.