User Instructions

NERO ONE GATEWAY

Smart System Controller

Connect your Gateway to your

network using an Ethernet cable

Connect the power supply to your

Gateway and allow it to fully boot

Go to setup.environexus.com and

follow the instructions to connect to

your Gateway

For further instructions & tips visit

support.environexus.com

Route cables through a 60mm hole

and screw the mount to the wall

Click the Gateway down onto the

wall mount, ensuring the Gateway

is rmly locked on to the clips

PAGE 1
NERO ONE GATEWAY Smart System Controller 1 1 2 1 Connect your Gateway to your network using an Ethernet cable 2 Connect the power supply to your Gateway and allow it to fully boot 3 Go to setup.environexus.com and follow the instructions to connect to your Gateway 2 1 Route cables through a 60mm hole and screw the mount to the wall 2 Click the Gateway down onto the wall mount, ensuring the Gateway is firmly locked on to the clips For further instructions & tips visit support.environexus.
PAGE 2
FCC Notice THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.