User manual

Edit Profile Window

Nero Recode

axis may be removed. So called ghost artifacts may also occur and

resolution may be lost.

Interpolate: One of the two interlaced fields gets discarded

completely, and each discarded line is replaced by an average of its

upper and lower neigbour from the other field. This is very fast, but

image details in the vertical axis may be removed.

Interpolate Adaptive: Similar to Interpolate, but discards only

sections which are not needed. Therefore, it is not as fast as

Interpolate, but gives better detail result.

Motion Adaptive: The amount of image motion and the motion

direction is taken into consideration for the interpolation.

The selected deinterlace method will be only applied if deinterlacing

of the source video is possible! If you choose Automatic, Nero

Recode takes the method that fits best.

Button

Encoder Settings

Opens a window with enhanced encoder settings for the selected

codec (see Encoder Settings Window→ 52).

Only active if encoder settings are available.

6.2 Encoder Settings Window

In the Encoder Settings window you can change settings for a specific codec. The window

is opened by choosing a codec in the Edit Profile window and clicking the Encoder

Settings button. We recommend to only change these settings if you have experienced

knowledge in this area!

Note that only those settings and values are shown that are possible and applicable for the

selected codec!