Instruction manual
7. PREPARINGABEVERAGE
7. 1 ONE CAPSULE (E. G. ESPRESSO INTENSO)
1
Adjust the drip tray position. Place the cup with the correct
cup size on the driptray. See "BEVERAGE EXAMPLES" or
package. Check if the water tank contains enough fresh
drinking water.
2
Open the locking handle. The machine switches on
automatically. The temperature selection button blinks
while the machine is heating up for approximately 40
seconds. Afterwards, the temperature selection button
lights steady red. The machine is ready to be used.
3
Make sure the rinsing tool is not inside. Insert the capsule
in the capsule holder. Insert it back into the machine. Close
the locking handle.
4
Use the control ring to setthe volume in accordance with
the number of bars shownon the capsule or select the
desired volume to your own taste. Choose XL beverage for
an extra big cup. Wait around 1.5 min if you want to prepare
a second extra big cup.
5
Press the start/stop button. The beverage preparation
starts. Do not open the locking handle during the extraction.
Wait until the extraction stops. The machine stops the
preparation automatically. The extraction can be stopped at
any time manually by pressing the start/stop button.
6
After finishing the preparation, the temperature selection
button and the volume display light blink for up to 8
seconds. During that time do not open the locking handle!
7
After the extraction is finished open the locking handle.
Remove the cup from the driptray.
8
Pull out the capsule holder. Remove the used capsule. Put
the used capsule in the dustbin.
9
Rinse both sides of the capsule holder with fresh drinking
water. Dry the capsule holder. Insert it back into the
machine. Enjoy your beverage!
12