User Manual

BEFORE FIRST USE

• Remove packaging materials such as cardboard, plastics or styrofoam and discard

appropriately.

• Wipe clean all the parts with a soft damp cloth or sponge and dry thoroughly.

• Do not immerse in water or place in dishwasher.

• TheGASKETsetsinbehindthewireguide.Beforeyourrstuse,gentlypullthe

GASKET out. (image 1)

• Handwashinwarmsoapywater.Dry,thenrmlypresstheGASKETbackinbehindthe

wire guide. (image 2)

• Slip CONDENSATION CATCHER onto the back of the unit.

• Make sure GASKET is properly installed in groove inside the LID.

ASSEMBLY

1. How to open the LID: When the LID of the cooker is at the “Closed-Lid Position” hold

the LID HANDLE and turn it about 1/8 of a turn clockwise, until you reach the “Open-

Lid Position”. Lift up on the LID HANDLE.

Note: For brand new units, the seal of the LID may be slightly stronger than normal

andmaybeslightlydifculttounlock.OncetheLIDhasbeenopenedandclosed

several times, it will loosen up.

2. How to close the LID: When the LID of the cooker is in

vertical position hold the handle and close it downwards

at the “Open-Lid Position”. After that, turn it in a counter

clockwise direction until you reach the “Closed-Lid Position”.

3. How to dismantle the LID: When the LID of the cooker is in the

upright vertical position, hold the LID with both hands, and adjust the height between

the LID and the upper edge of the cooker to around 4 inches (image 3). Then turn it

in a counter clockwise direction until you reach the “Closed-Lid Position” (image 4).

Then lift the LID up and away from the “Smart Canner” body (image 5).

WARNING -

Hot steam will periodically be released

out of the STEAM RELEASE VENT. Be sure nothing is

directly above this area when using the “Smart Canner”.

3 5