Use and Care Manual

3
English
Before rst me use
1. Read and understand all instrucons and keep for future reference.
2. Remove all packaging and labels.
3. Clean all parts, except Base, following ‘Care and Cleaning ’ secon in this book.
CAUTION: KETTLE IS MADE OF GLASS, ALWAYS USE THE HANDLE FOR LIFTING
AND USE CARE WHEN USING OR CLEANING.
4. Wipe the Base with a damp cloth and dry thoroughly. WARNING: NEVER IMMERSE
THE BASE OR KETTLE IN WATER OR ANY OTHER LIQUID.
Operang Instrucons
1. Unwrap cord and place base staon on a sturdy and at surface.
2. Open the kele lid by pressing the lid release buon located on the handle. Lid will
hinge open automacally.
3. Fill with cold water up to the desired level between the minimum and maximum
levels for the proper funconing.
• Do not overll past the maximum level. Boiling water may spill out and cause
severe burn injury.
• Never ll the kele with anything other than water, do not add instant soup or
use to heat any food.
4. Gently press lid down unl locking into closed posion.
5. Place kele onto base staon. Be sure kele is securely placed, it should be at and
center on base. If correct, connect cord to electrical outlet.
6. Gently press the ON/CANCEL buon then press desired temperature seng.
7. When water reaches the set temperature the control buon will begin to ash,
indicang the heang cycle is complete and will keep water warm for 30 minutes. If
select BOIL the kele will cycle once and turn o.
8. Li the kele by the handle and slowly lt to pour water from spout into cup.
9. Before disconnecng plug from electrical outlet, always turn o the kele or li
kele from base staon
.
Care and Cleaning Instrucons
• Before disconnecng plug from electrical outlet, always turn o the kele or li kele
from base staon.
• Remove cord from electrcal outlet and make sure kele has cooled before handling.
• Clean the base by wiping with clean, damp, cloth. Do not use abrasive cleaners or
scouring pads. Wipe dry.
• Rinse interior of kele using clean water and gently wipe dry using lint-free cloth.
• Do not leave standing water in the kele. Always discard unused water and dry
interior surfaces when not in use.
• To remove lter, open lid and li tab on lter to inside. Filter will hinge, grasp with
ngers and gently remove.
• It is normal to see the stainless steel cover of the heater plate at the boom of the
kele to change color aer use or if your water has high iron content brownish stains
may appear and can be removed with cloth and mild stain remover.
• Boiling water can leave behind harmless, white calcium deposits inside the kele
and mainly on the stainless steel heater cover. Use a commercially available de-
calcifying agent or add 1 oz. vinegar to water, ll to minimum level and run BOIL cycle.
Hint: If the kele switches o before water is reaches set point, it may need to be
decalcied. Frequency depends on hardness of water and number of uses.