Instructions / Assembly

English

Functions

• Cancel Button - Stops the unit at any time.

• Seal Only - For sealing a bag without vacuum.

• Vacuum/Seal - For vacuuming the bag and automatically sealing it when

vacuum is complete.

• Indicator Lights - Indicates the status of vacuum or seal process.

• Unlock Buttons - On the right and left side of the cover. Press down to unlock.

In the locked position, they secure the lid in place while the vacuum packing

cycle is under way in bags; they release automatically.

• Lid - Opening the lid into the xed raised position allows you to position the bags

before starting the vacuum packing process.

• Vacuum Chamber - Position the open end of the bag inside the chamber, draws

air from the bag and collect any excess liquid.

• Sealing Gasket - Presses the bag onto the sealing strip.

• Sealing Bar - Place bag to be sealed over this bar.

PAGE 1
• • • • • • Cancel Button - Stops the unit at any time. Seal Only - For sealing a bag without vacuum. Vacuum/Seal - For vacuuming the bag and automatically sealing it when vacuum is complete. Indicator Lights - Indicates the status of vacuum or seal process. Unlock Buttons - On the right and left side of the cover. Press down to unlock. In the locked position, they secure the lid in place while the vacuum packing cycle is under way in bags; they release automatically.
PAGE 2
Operating Instructions English MAKING A BAG WITH THE ROLL 1. Pull the bag material from the roll to the suitable length you want and cut (Pull out enough of the bag roll to hold items to be vacuum packed plus an additional 3” inch (allow another 1 inch for each time the bag will be resealed.) then close the rear lid. 2. Open the lid and place either open end of bag material on Sealing Strip, close it. Press down on the lid until two “click” sounds are heard. 3.
PAGE 3
Vacuum Sealing Tips • Do not overfill the bags; leave enough space at the open end of the bag so that the bag can be placed on the vacuum chamber more positively. • Do not wet the open end of the bag. Wet bags may be difficult to melt and seal tightly. • Clean and straighten the open end of the bag before sealing. Make sure nothing is left on the open area of the bag, no wrinkle or creases should appear on the open panel, foreign objects or creased bags may cause difficulty to seal tightly.