Installation Manual

Install Heat Link
See page 15 for sticker.
7. Configure the programmer
If there’s a programmer that controls
hot water and heating, set the
heating controls to ALWAYS ON. If the
programmer only controls heating,
then remove it. The Heat Link will
control heating in its place.
Lastly, turn the power to the heat back on.
6. Attach the Heat Link
Use the included screws to attach the
HeatLink to a wall near the boiler or
junction box, making sure to leave
30cmspace on all sides. When you’re
done, put the Heat Link cover back on.
Check page 23 for placement info.
TIP: Put this sticker on the
programmer to remind
homeowners not to adjust it.
Installation step-by-step
INSTALL IN A NEW SPOT
27