Manual
GigaBit Fiber In-Line Regeneration Taps
6
Connecting to the Monitoring Devices
1..Supply.power.to.the.Tap.using.the.power.supply.adapter.included.with.the.
unit.Verify.that.the.power.LED.illuminates
Note: _______________________________________________________________
The second power supply is available to support the ow of trafc to the
monitoring device should the rst power supply fail. If the rst power supply
is unavailable, the second power supply supplies all power for the Tap.
______________________________________________________________________
2..Connect.the.twin-duplex.end.of.the.cable.into.the.appropriate.monitoring.
device.port.to.monitor.the.link
3..Connect.the.twin-duplex.end.to.the.appropriate.monitoring.device.port.to.
monitor.the.link.The.SC.connectors.on.the.Custom.Monitor.Cable.contain.
RX.connections.only
Figure 6: Connecting the Monitoring Devices
4..Repeat.Steps.2-3.for.each.monitoring.device.you.wish.to.connect.to.the.
Regeneration.Tap
Regeneration Tap™
www.netoptics.com
B
A
Monitor
Network
LASER
CAUTION!
LINK
1
2
B
A
1 2 A B3 4
To Monitor NIC
To Monitor NIC
DTE
DCE
To Monitor NIC
To Monitor NIC
Standard SC/SC Cable
Net Optics Custom
Monitor Cable