Owner manual

GigaBit Fiber Port Aggregator Tap
7
Connecting the Monitoring Device
To protect the Port Aggregator Tap, the SFP slots are lled with temporary
plugs. If you are installing only one SFP, leave the plug in Monitor Port 2 to
protect the Port Aggregator Tap. You must install the SFP before connecting to
the monitoring device.
To connect the Monitor Ports:
1. Remove the SFP from its protective packaging.
2. Remove the temporary plug from Monitor Port 1.
3. Insert the SFP in the Monitor 1 Port until you hear it click into place.
4. Connect Monitoring Port 1 to the appropriate port on the monitoring
device using an RJ45 CAT5e cable to monitor the
A and B links.
5. If you are installing two SFPs, repeat Steps 1 through 4 for Monitor Port 2.
Figure 5: Connecting the Monitoring Device
B 1A
Passive 10/100 Ethernet
Dual Port Aggregator with
Passive 10/100 Ethernet
Dual Port Aggregator with
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
2
10
100
LINK
ACT
®
1
2
www.netoptics.com
Active ResponseActive Response
TX
TX RX
TX
TX RX
Application Illustration
Network
B 1 2A
Monitor
®
P a s s i ve
GigaBit SX
Dual Port Aggregator
12 Volt 3.0 Amp
+
OUTPUT PIN ASSIGNMENT
21
12 Volt 3.0 Amp
+
OUTPUT PIN ASSIGNMENT
21
®
P a s s i ve
GigaBit
Dual Port Aggregator
To Monitoring Device
www.netoptics.com
Port Aggregator
1
Network Monitor
2
A B
1
2
2
1
B
A
LINK