Owner manual

GigaBit Fiber Port Aggregator Tap
3
About this Guide
This Guide provides you all the information you need to install and operate
the GigaBit Fiber Port Aggregator Tap. Please read the entire Guide before
attempting to install or operate the Tap.
This Guide covers the following models:
Part Number Description
TPA-SX4-SFP GigaBit Port Aggregator, multimode SX ber, 60/40 split
ratio, two SPF monitor ports
TPA-SX5-SFP GigaBit Port Aggregator, multimode SX ber, 50/50 split
ratio, two SPF monitor ports
TPA-LX4-SFP GigaBit Port Aggregator, singlemode LX ber, 60/40 split
ratio, two SPF monitor ports
TPA-LX5-SFP GigaBit Port Aggregator, singlemode SX ber, 50/50 split
ratio, two SPF monitor ports
TPA-50SX5-SFP GigaBit Port Aggregator, multimode 50um SX ber,
50/50 split ratio, two SPF monitor ports
Product Diagram
Figure 4: Front Panel
LED Indicators
• PWR 1/ PWR 2: Main and Redundant Power. If the Tap is deployed with
both power supplies, both LEDs illuminate when the Tap is plugged in. If
an LED is off, this indicates that the corresponding power supply is not
functioning.
• Link/Activity Indicators: If a good link is established, the LED illu-
minates a steady green. If there is current activity on this link, the LED
ashes.
Power LEDs
www.netoptics.com
Port Aggregator
1
Network Monitor
2
A B
1
2
2
1
B
A
LINK
Monitor Ports
with plugs
Network Ports
Link LEDs