User guide

Multi-Station Power Supply
4
Figure 4: Connecting Power to Taps
10/100 Ethernet Tap
Dual Power for
Redundancy
DC connector leads
DC connector leads
Power 2
Power 1
Product Diagrams
Installation
To install the Multi-Station Power Supply, you simply need to connect the input
power and plug the DC output connector leads into supported Net Optics de-
vices. Details of these procedures are given in the following sections. You can
make the connections in any order: The input power can be connected either
before of after the outputs. Connections can be made and removed while the
unit is under power.
To disconnect the unit, simply unplug or disconnect the power cords from the
chassis, and the DC output connector leads from the Net Optics devices. The
inputs and outputs can disconnected in any order; however, for the DC model,
the earth grounds should be left in place as long as any other connections are
present.