User guide

Multi-Station Power Supply

Connecting the Multi-Station Power Supply to Net Optics Taps

1. Unpack the Multi-Station Power Supply, and verify that you have all the

necessary components to successfully install the Taps.

2. Connect one of the DC connector leads from Power 1 into the DC jack 1

on the rst Tap. If present, remove the rubber cap from the barrel connec-

tor before plugging it into the Tap.

3. Connect one of the DC connector leads from Power 2 into the DC jack 2

on the rst Tap. If present, remove the rubber cap from the barrel connec-

tor before plugging it into the Tap.

Note: ________________________________________________________________

Each Tap should have a DC connector lead from both Power 1 and Power 2

in order to have power redundancy.

______________________________________________________________________

4. Repeat Steps 2 and 3 above for connecting additional Taps to the Power

Module.

Connecting AC Input Power to the Multi-Station Power

Supply (AC model)

1. If you have not already done so, unpack the Multi-Station Power Supply and

verify that you have two apropriate AC power cords.

2. Connect one of the AC power cords to one of the AC power connector on

the rear of the Multi-Station Power Supply.

3. Install a power supply clip over to keep the AC power cord from accidently

being unplugged from the AC power connector.

4. Plug the other end of the cord into an AC power source.

5. Repeat steps 2-4 for the other AC power cord, connecting it to the remaining

AC power connector on the rear of the Multi-Station Power Supply.