SDS

MATERIAL SAFETY DATA SHEET
REVISION: 0 ISSUE DATE: 2/4/2015
SECTION 11 TOXICOLOGICAL INFORMATION
SECTION 12 ECOLOGICAL INFORMATION
SECTION 13 DISPOSAL CONSIDERATIONS
SECTION 14 Transportation
1
1.1
1.2
2
2.1
3
3.1
3.2
a
b
c
d
SECTION 15 REGULATORY INFORMATION
OSHA Hazard Communication Standard ( 29 CFR 1910.1200)
Hazardous Non-hazardous
SECTION 16 OTHER INFORMATION
Battery Number HHW451421SA
Nominal Voltage 3.7
Minimum PACK Capacity 90mAh
Battery Mass 1.8-2.4g
Equivalent Lithium Content 0.027g
Test NO Criteria Result
38.3.4.1 Passed
38.3.4.2 Passed
38.3.4.3 Passed
38.3.4.4 Passed
38.3.4.5 Passed
38.3.4.6 ------
38.3.4.7 Passed
38.3.4.8 ------
For the bar cells,the lithium content can not overpass 20Wt/h;
Incineration: incineration should never be performed by battery users but eventually by trained professionals in authorized facilities with proper gas and fumes treatment.
All the cell and battery must be verified to meet with all the requirements in Part 3 -38.3 item (UN38.3 tests) for "Recommendations on the Transport of Dangerous Goods, Manual of Tests
and Criteria" .
For the batteries, the lithium content can not overpass 100Wt/h;
Meet with UN Test Requirement
There is no contamination during normal operation and use. Lithium batteries should have their terminals insulated prior to disposal, do not throw away a used battery and provide them for recycling
company.
Open cells should be treated as hazardous waste. If the leakage or other material is Released, we should take actions as follows:
Leave the area, allow the batteries to cool down, let the vapors to dissipate .
Avoid skin and eye contact or inhalation of vapors. Remove spiller liquid with absorbent and incinerate after.
Civil Aviation Organization (ICAO) Technical Instructions (2015-2016Edition), the International Air Transport Association (IATA) Dangerous Goods Regulations (56th Edition, 2015). Packing
can be transported in nonrestrictive material and as Non-Dangerous Goods as they meet all the requirements in below:
Landfilling:According to the proper laws and regulations in different countries or areas, the battery should be buried deeply in the specified place;
Lithium content requirement
49 CFR(Code of Federal Regulations)Sections 173-185 Lithium batteries and cells. the UN Recommendations on the Transport of Dangerous Goods, Manual of Tests and Criteria 38.3 Lithium batteries,
Recycling: Send to authorized recycling facilities to get Co,Cu and Al,eventually through licensed waste carrier;
Thermal Test
instruction 965 Section IB or II for Lithium Ion battery, the International Maritime Dangerous Goods (IMDG) Code (2010 Edition) with special provision 188 & 230, US Harzardous Materials
Regulations
Package Requirement
4th revised edition(UN3480) as "non-dangerous goods" or "non-hazardous materials". The mentioned batteries are complied with the special provision, Section I of PI965 to PI967. These lithium
batteries
Lishen’s SP451421AB Lithium Ion batteries are considered to be “rechargeable batteries” and meet the requirements of transportation by th U.S. Department of Transportation,
The cell and battery must be packaged specially and singly, and put into hard outer package to prevent short-circuit if they do not be assembled in finished equipments (such as mobile
phone,camera,NBPC.and so on)
No mass loss,leakage,venting,disassembly,rupture,and fire.OCV should not be less than 90%
before testing
Cobalt and its compounds can pose a threat if released to environment. The detail information are showed in waste disposal method in Section 13 "Disposal Consideration".
Forced Discharge
Shock
External temperature should not exceed 170degC.No disassembly, and fire within six hours of
this test.
No disassembly, and fire within seven days of this test.
Overcharge
No disassembly, and fire within seven days of this test.
Impact
External Short Circuit
Every package weight can not overpass 10kg if the batteries can not be assembled in finished equipment.
There is no hazards in accordance with the UN recommendations test.(UN manual of tested and criteria 38.3)
The cell quantity is more than 24pcs or the battery quantity is more than 12pcs, they must be asked to meet with the requirements in blow besides they are assembled in finished equipment.
Every package must pass 1.2mm fall test in any direction. No damage for the cells and batteries, no move and touch together, no cells or batteries escape from the package.
Every package must be marked in the content that the packages are loaded in lithium cells or batteries, also add new lithium iron operation label , also need point out the corrective actions
when the packages are damaged.
Every batch shipment must be appendixes document which should contain the content that the packages are loaded in lithium cells or batteries, also need point out the corrective actions when
the packages are damaged.
Waste Disposal method Opened cells should be treated as hazardous waste.
No mass loss,leakage,venting,disassembly,rupture,and fire.OCV should not be less than 90%
before testing
Altitude Test
This product does not elicit toxicological properties during routine handling and use.
External temperature should not exceed 170degC.No disassembly, and fire within six hours of
this test.
Vibration
No mass loss,leakage,venting,disassembly,rupture,and fire.OCV should not be less than 90%
before testing
Test Item
No mass loss,leakage,venting,disassembly,rupture,and fire.OCV should not be less than 90%
before testing
√