Datasheet

2
Cable length, Wiremap, and Location
Users can easily find opens, shorts, miswires, and split pairs in three dierent ways:
• On non-terminated cable
• With a WireView Cable Identifier
• Check patch cord with the built-in wiremap port on the side of the LinkRunner AT
Cable Location
Locate cable runs with toning, switch port advertisement, switch port link light blinking, and
remote cable identifiers. Toning supports both analog and digital IntelliTone modes.
Discover Nearest Switch and VLAN
The LinkRunner AT uses the IEEE Link Layer Discovery Protocol (LLDP), along with the Cisco
and Extreme Discovery Protocols (CDP and EDP) to display the nearest switch model, slot, port
and VLAN configured.
The LinkRunner AT displays the following critical nearest switch information:
• Switch name and model
• Chassis, slot and port
• Switch IP address
• Voice and Data VLAN IDs
• Duplex and speed (actual and advertised)
• Signal Strength
• Connection (MDI or MDI/X)
• PoE voltage and power (actual and test limit)
• Graphical representation of power on pairs
netally.com/products/linkrunner
Switch information
Cable wiring validation