User Manual
Table Of Contents
- Contact Us
- Introduction
- Home and Android Interface
- LinkRunner 10G Settings and Tools
- Software Management
- LinkRunner 10G Testing Applications
- AutoTest App and Profiles
- Ping/TCP Test App
- Capture App
- Discovery App
- Path Analysis App
- Performance Test App
- iPerf Test App
- Link-Live Cloud Service
- Cable Test App
- Specifications and Compliance
negotiation to succeed. If the UPOE Class is
selected on your LinkRunner but LLDP is
not enabled on your Cisco switch, nego-
tiation will fail.
LLDP
This toggle button appears if Class 4 (25.50 W) is
selected. Enable this setting if LLDP is enabled
on the switch you are testing. Class 4 LLDP
must be enabled on the switch for AutoTest to
detect it successfully. If the LLDP setting is
enabled but your switch does not support
LLDP, negotiation will fail.
Requested Power (W)
This setting appears if UPOE is selected in the
Powered Device Class setting shown above or if
the Powered Device Class is set to PoE Injector
and TruePower is enabled. Touch to enter a
Requested Power other than the default, if
needed. If you touch the backspace button on
the pop-up number pad and clear the default
value, the valid power range is displayed.
AutoTest App and Profiles
186