User Manual

Device Name: Enter the IP address or DNS
name of the target.
IP Protocol Version: IPv4 is used by default.
Touch the field to enable IPv6 instead.
Interface: This setting determines the
LinkRunner port from which the test runs.
Touch the field to select Any Port, Wired
See Test and Management Ports for explan-
ations of the different ports.
Number of Tests: Touch to select the number
of Ping or TCP connect tests you want to run.
The default setting of Continuous keeps
running tests until you touch the STOP button.
Protocol: Tap to select the Ping or
TCPConnect protocol for the test.
Some of the following settings depend on the
selected protocol.
Frame Size (bytes): This setting only appears if
the Ping Protocol is selected. It specifies the
total size of the payload and header the
LinkRunner sends. Tap a radio button to select
a new size, or enter a Custom Value from 64 to
1518 bytes.
Ping/TCP Test App
263