User Manual

NetBotz

Spot Fluid Sensor (NBES0301)

Installation Instructions

The NetBotz Spot Fluid Sensor enables you to monitor a remote location for the presence of any

liquid with a resistivity of less than 2 MOhms per cm (including distilled water).

Note: You can extend the length of the cable up to 30.5 m (100 ft) using the RJ-45

coupling and standard CAT-5 cabling.

Installation

1. Place the fluid-sensing portion of the NetBotz Spot Fluid Sensor at the location that you want

to monitor. The four fluid sensor contacts should be in direct contact with the surface

Plug the cable into an available Sensor Port on your NetBotz appliance

Spot Fluid Sensor

Plastic insulation sheet

203-mm (8-in) tie wraps (10)

Adhesive cable tie holders (5)

RJ-45 coupling (1)

PAGE 1
NetBotz® Spot Fluid Sensor (NBES0301) Installation Instructions The NetBotz Spot Fluid Sensor enables you to monitor a remote location for the presence of any liquid with a resistivity of less than 2 MOhms per cm (including distilled water). Plastic insulation sheet Spot Fluid Sensor 203-mm (8-in) tie wraps (10) Adhesive cable tie holders (5) RJ-45 coupling (1) Note: You can extend the length of the cable up to 30.5 m (100 ft) using the RJ-45 coupling and standard CAT-5 cabling. Installation 1.
PAGE 2
Using the Insulator Sheet on a Conductive Surface The NetBotz Spot Fluid Sensor uses electronic circuits to detect the presence of fluid. If the sensor contacts are shorted, the fluid detection circuits will not work. Shorting can occur when the sensor is placed on a metal surface, or on some materials, such as cement flooring (particularly cement that is wet), that may be conductive and grounded. Place the Spot Fluid Sensor on the provided insulator sheet to avoid shorting the contacts.