User Manual

NetBotz

Door Switch Sensors for APC

Racks (NBES0313)

Installation Instructions

Inventory

Installation

Caution: Make sure you connect this sensor to a Sensor port on applicable NetBotz

products. See your NetBotz product documentation for details.

Note: You can extend the length of the sensor cable up to 30.5 m (100 ft) using the

RJ-45 coupling and standard CAT-5 cabling.

Switch with connected 1.57-m (62-in) door switch

sensor cable

Magnet

M3 hex nut (2)

6-32 x 5/16-in screw (4)

Wire clip (8)

63.5-mm (2.5-in) dual adhesive

tape (2)

203-mm (8-in) tie wrap (5)

Adhesive cable tie holder (5) RJ-45 coupling (1)

PAGE 1
NetBotz® Door Switch Sensors for APC® Racks (NBES0313) Installation Instructions Inventory M3 hex nut (2) Magnet 6-32 x 5/16-in screw (4) Switch with connected 1.57-m (62-in) door switch sensor cable 203-mm (8-in) tie wrap (5) Wire clip (8) 63.5-mm (2.5-in) dual adhesive tape (2) Adhesive cable tie holder (5) RJ-45 coupling (1) Installation Caution: Make sure you connect this sensor to a Sensor port on applicable NetBotz products. See your NetBotz product documentation for details.
PAGE 2
® 1 Front Door of NetShelter SX Enclosure 2 Rear Door of NetShelter SX Enclosure Customer support and warranty information is available at the APC Web site, www.apc.com. © 2011 Schneider Electric. All rights reserved. All Schneider Electric trademarks are property of Schneider Electric S.A.S or their subsidiaries. Other trademarks are property of their respective owners.