User's Guide

 3G36W-VUserGuide
www.netcomm.com.au 23
3G36W-V User Manual
4.2.5 AdvancedRouting
Thispageallowsyoutocongurestaticanddynamicroutingrulesforyour3G36W-V.
4�2�5�1 Advanced Routing – Static
StaticRoutingallowscomputersthatareconnectedtoyour3G36W-VtocommunicatewithcomputersonanotherLANsegmentwhich
areconnectedtoitviaanotherrouter.Tosetarule,youneedtospecifythefollowing:
• Destination
• Subnetmask
• Gateway
• Interface
4�2�5�2 Advanced Routing – Dynamic
DynamicRoutingusestheRIPprotocoltoallowthe3G36W-Vtoadapttochangesinthenetwork.RIPenablesthedevicetodetermine
thebestrouteforeachpacketbasedonthe“hopcount”ornumberofhopsbetweenSourceandDestination.ToenableDynamic
Routing,selectEnablefromthedropboxandclickApply.
4.2.6 DHCPClientList
ThispageallowsyoutoviewthecurrentDHCPclientsthathaveobtainedIPleasesfromyour3G36W-V.TheMACaddress,assigned
IPaddressandtheexpiryperiodisshownforallcomputerswhohaveautomaticallyobtainedaddressesfromthe3G36W-V.Please
notethatthislistisstoredinthedevice’svolatilememory,andisthereforeclearedifthedeviceisresetorifanychangedareappliedto
conguration.