User's Guide

38 of 64
CBRS Survey UE – User Guide
UG01287 v0.6 December 1, 2020
Operator settings
The Operator settings page enables you to select which frequency band you will use for your connection and
enables you to scan for available network operators in your area.
You may want to do this if you’re using the antenna in a country with multiple frequency networks that may not all
support LTE. You can select the antenna to only connect on the network frequencies that suit your requirements.
Operator settings
The operator settings feature allows you to select whether to allow the antenna to automatically select a network
or to manually scan for a network to which the antenna is locked.
Figure 30 - Operator settings
To scan for available networks, set the Select operator mode from Automatic to Manual then click the Scan
button. This operation can take a few minutes and requires that the packet data session be disconnected prior to
scanning.
A list of the detected service carriers in your area is displayed.
Figure 31 - Detected operator list
Select the most appropriate service from the list shown and click the Apply button.