User's Manual

12
Outdoor Wireless Antenna (NRB-51)
www.netcommwireless.com
UM-00017 rev 1.0
The images below show the correct connection of the components.
Note that the white USB to TAG connect ribbon cable is only required for debug and is not part of the actual deployment.
RG PORT NUMBER
VLAN ID
IP ADDRESS RANGE
FUNCTION
1
NIL
-
Trunk (to OWA)
2
4001
192.168.11.X
Provides connectivity to admin VLAN on the OWA.
3
4002
192.168.12.X
Provides connectivity to Data VLAN on the OWA.
4
4003
192.168.13.X
Provides connectivity to IMS VLAN on the OWA.
1. Using RJ45 Ethernet cable, connect the OWA unit to the blue Ethernet port of the PoE injector. This connection is
represented by the Blue Ethernet cable in the picture above.
1. Using RJ45 Ethernet cable, connect one end to Ethernet port 1 of the RG and the other end to the red Ethernet port of the
PoE injector. This connection is represented by the Yellow Ethernet cable in the picture above.
2. Connect the PoE injector’s power cable to a wall socket and turn on the power. Turn on the PoE-02’s power switch.
3. Open a command prompt (press Windows key and type
cmd
then press Enter) and type
ipconfig.
Press the Enter key.
4. Confirm that the Ethernet interface has been assigned an IP address in the 192.168.11.X range.
Before proceeding with tests on the data VLAN, ensure that you have connected an appropriate cellular antenna to the
MAIN antenna socket of the OWA.