User's Manual

www.netcommwireless.com
Outdoor Wireless Antenna
13
UM-00017 rev 1.0
Firmware Upgrade on Windows 8/8.1/10 PCs
Installing the ADB driver
Extract the netcomm_nrb51_adb_driver.zip archive to a folder on the PC. On 32-bit Windows systems, run DPInst_x86.exe and on
64-bit Windows systems, run DPInst_x64.exe. Follow the installation wizard steps.
Installing the USB driver
1. Double click on the adb-setup-1.3.exe file that you downloaded to install the USB driver. The main screen displays an
install confirmation.
2. Type
Y
and press Enter.
When prompted to install ADB system-wide, press
Y
and then Enter.
When prompted to install device drivers, press
Y
and then Enter.
3. On the Device Driver Installation Wizard window that appears, click the Next button.
On the Windows Security pop-up window, click the Install button, then click the Finish button.
The ADB installer window closes.
4. Double click on the minimal_adb_fastboot_v1.1.3_setup.exe file.
Click the Next button through the prompts then click the Install button.
When the installation has completed, click the Finish button. Close the Command Prompt window that appears.
5. To verify correct installation of the tool, open a command prompt (press Windows key and type
cmd
then press Enter).
Change directory to “C:\Program Files (x86)\Minimal ADB and Fastboot” by typing
cd “C:\Program Files
(x86)\Minimal ADB and Fastboot”
then pressing Enter.
Type
adb devices
in the command prompt, then press Enter.
Verify that the device is listed in “List of devices attached”.
6. On the Windows PC, create a local directory then copy nrb-51_v_<version number>.zip into the directory.
7. Extract the archive into “C:\Program Files (x86)\Minimal ADB and Fastboot”.
8. Run the following command from Minimal ADB Tool folder to upgrade the recovery image:
C:\Program Files (x86)\Minimal ADB and Fastboot>update_bootloader.bat