User's Manual

128
NetComm Wireless 4G M2M Router
www.netcommwireless.com
v1.0
Sleep settings
Use the Sleep mode drop down list to select a condition under which the router should enter the sleep state.
Sleep after timer
When this mode is selected, the router will enter the sleep state after the number of minutes specified in the Sleep after field,
regardless of the state of the ignition pin.
Figure 128 - Sleep after timer
Sleep at scheduled time
When this mode is selected, the router goes to sleep at the time specified in the Schedule sleep at field, regardless of the state of
the ignition pin. Enter the time in 24 hour format without the semi-colon.
Figure 129 - Sleep at scheduled time
Sleep triggered by ignition pin
This mode sets the router to enter sleep state when the signal on the ignition pin reaches the specified value.
Figure 130 - Sleep triggered by ignition pin
Use the Sleep when ignition pin goes setting to select Low or High. By default, this is set to Low. Additionally, the router will stay on
for the number of minutes specified in the Remain awake after ignition off field. The minimum value for this field is 2 minutes with the
maximum being 255 minutes.