User's Manual

UM-00003
www.netcommwireless.com
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
45
2. Configure the LAN IP Address of Access Point 1. In this example, it is set to the default address of 192.168.1.1:
Figure 46 - WDS - Access Point 1 LAN IP Setup
3. Enable the DHCP Server on Access Point 1:
Figure 47 - WDS - Access Point 1 DHCP Server Settings
4. Under Wireless Setup, select a frequency channel to use for WDS. You may use any channel except for AUTO. Enter an
SSID to identify Access Point 1 and set Network Authentication to Open. If you wish you can enable WEP Encryption and
enter a Network Key of either 10 or 26 characters in length. Set Access Point 1 to Repeater mode and enter the MAC
address of the access point that will connect to it in the AP MAC Address1 field. The MAC address of Access Point 2 is
listed on the same page under Wireless Settings > Basic under the Wireless Distribution System (WDS) section. You can
add up to 4 access points in WDS Mode. When you have entered the required information, click Save: