User's Manual

Interfaces

The following interfaces are available on the CDMA M2M Router:

Figure 3 - Interfaces

ITEM DESCRIPTION

Main antenna socket

SMA female connector for an optional external antenna (not supplied). The main

internal antenna is disabled when an external antenna is connected but the auxiliary

antenna remains active to provide (where possible) diversity assistance.

Power LED Indicates the power status of the device and whether the device is in recovery mode.

Network LED Indicates the network status.

Signal strength LEDs Indicates the signal strength and network type.

RJ45 PoE Ethernet port

Connect one or several devices via a network switch here. This port can also

optionally receive Power over Ethernet (802.3af PoE) in which case the DC power

supply can serve as backup power source if required.

Reset button

Press and hold for less than 5 seconds to reboot to normal mode.

Press and hold for 5 to 15 seconds to reboot to recovery mode.

Press and hold for 15 to 20 seconds to reset the router to factory default settings.

Two-way captive power

Connect power source here. Power wires may be terminated on optional terminal

block and connected to DC input jack. Operates in the 8-35V DC range.

Table 5 – Interfaces

NetComm Wireless CDMA M2M Router