Network Router User Manual

YML854 Rev1 NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4WnNB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide
www.netcomm.com.au 55
After setting up the WAN IP and DNS server information, click Next to open the following page.
On the Configure LAN side Settings page, you have to fill in the data requested.
Primary IP Address & Subnet Mask:
Key in the information that offered by your ISP for the LAN connection, e.g., 192.168.1.1 for IP
address and 255.255.255.0 for subnet mask.
MTU:
(Please refer to the PPPoA/ PPPoE section.) The default MTU setting here is 1500. You may modify it
if necessary.
Configure the secondary IP Address and Subnet Mask for LAN interface:
Check this box to set up a secondary IP Address to connect to your router if they are not included in
the range that DHCP server accepts. You have to key in the information received from your ISP for
the LAN connection, e.g., the secondary IP is 10.11.80.81 and the mask is 255.255.255.248 in the
example illustrated in the figure.