Network Router User Manual

YML854 Rev1 NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4WnNB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide
www.netcomm.com.au 81
IP Routing – Dynamic Routing (NB6Plus4W/NB6Plus4Wn only)
Routing Information Protocol (RIP) is utilized by means of exchanging routing information between routers. It
helps the routers to determine optimal routes. This page allows you to enable/disable this function.
RIP Version:
It incorporates the RIP information when receiving and broadcasting the RIP packets. From the drop
down menu, select a RIP version to be accepted, 1, 2 or both.
Operation:
There are two modes for you to choose, Active and Passive. Select Active for transmitting and
receiving data, or select Passive for receiving data only.
Enabled:
Check Enabled to enable the RIP function on different interface. Otherwise, disable this function.
Click Apply to invoke the settings set here.