User Manual
Table Of Contents
- User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 4 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- The WG111 status line displays a speed lower than 54 Mbps
- The WG111 Smart Wireless Assistant keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111 card has received a valid IP address
- How to use Windows XP’s own Wireless Configuration Utility
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
3-12 Basic Setup
202-10026-01
Verify wireless connectivity to your network.
a. Verify that the status monitor information at the bottom of the utility matches your
wireless network.
b. Check the color of the WG111 icon in the Windows system tray: green or yellow
indicates a working connection; red indicates no connection.
c. Check the WG111 LED: blinking means attempting to connect; solid indicates a good
connection; off means the WG111 is not plugged in.
d. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see Chapter 4, “Troubleshooting”.