User's Manual
Table Of Contents
- Reference Manual for the Model DG834PN 108 Mbps RangeMaxTM Wireless ADSL Modem Router
- Contents
- Chapter 1 About This Guide
- Chapter 2 Introduction
- Chapter 3 Connecting the Router to the Internet
- What You Need Before You Begin
- Manually Configuring Your Internet Connection
- Chapter 4 Wireless Configuration
- Chapter 5 Protecting Your Network
- Chapter 6 Managing Your Network
- Chapter 7 Advanced Configuration
- Chapter 8 Troubleshooting
- Appendix A Technical Specifications
Reference Manual for the Model DG834PN 108 Mbps RangeMax
TM
Wireless ADSL Modem Router
3-6 Connecting the Router to the Internet
August 2005
c.
Connect the ADSL port (B) of the DG834PN to the ADSL connector of the two-line filter.
Note: Improperly connecting a filter to your DG834PN will block ADSL signals and prevent
connecting to the Internet.
d. Connect the NRJ-45 Ethernet cable (C) from a LAN port of your DG834PN to the
Ethernet adapter in your computer.
Note: The unshielded RJ-45 Ethernet cable is supplied for the connection of the NETGEAR
product to your PC and is not intended for connection to the telecommunications network.
e. Plug in the router and verify the following:
• The power light is lit after applying power to the router.
• The ADSL link light is solid green, indicating a link has been established to the
ADSL network.
f. Now, turn on your computer and verify the following:
• The local lights are lit for any connected computers.
• If software usually logs you in to the Internet, do not run it.
• The Internet Explorer Tools Internet Options Connections page should be set to
“Never dial a connection.”
g. Install a filter on each phone device that shares the phone line with your router.
Note: Use one-line filters for connecting additional phones.
+j
.
j
B
C