User's Manual
Table Of Contents
- Reference Manual for the Model DG834PN 108 Mbps RangeMaxTM Wireless ADSL Modem Router
- Contents
- Chapter 1 About This Guide
- Chapter 2 Introduction
- Chapter 3 Connecting the Router to the Internet
- What You Need Before You Begin
- Manually Configuring Your Internet Connection
- Chapter 4 Wireless Configuration
- Chapter 5 Protecting Your Network
- Chapter 6 Managing Your Network
- Chapter 7 Advanced Configuration
- Chapter 8 Troubleshooting
- Appendix A Technical Specifications
Reference Manual for the Model DG834PN 108 Mbps RangeMax
TM
Wireless ADSL Modem Router
7-4 Advanced Configuration
August 2005
• LAN IP addresses—192.168.0.1
• Subnet mask—255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)-designated private address
range for use in private networks, and should be suitable in most applications. If your network has
a requirement to use a different IP addressing scheme, you can make those changes in this menu.
Figure 7-2: LAN IP Setup Menu
The LAN TCP/IP Setup parameters are:
• IP Address
This is the LAN IP address of the wireless ADSL modem router.
• IP Subnet Mask
This is the LAN Subnet Mask of the wireless ADSL modem router. Combined with the IP
address, the IP Subnet Mask allows a device to know which other addresses are local to it, and
which must be reached through a gateway or wireless ADSL modem router.
• RIP Direction
RIP (Router Information Protocol) allows a wireless ADSL modem router to exchange routing
information with other routers. The RIP Direction selection controls how the Wireless ADSL
Modem Router sends and receives RIP packets. Both is the default.
— When set to Both or Out Only, the wireless ADSL modem router will broadcast its routing
table periodically.
— When set to Both or In Only, it will incorporate the RIP information that it receives.