User's Manual
Table Of Contents
- User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 4 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- The WG111 status line displays a speed lower than 54 Mbps
- The WG111 Smart Wireless Assistant keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111 card has received a valid IP address
- How to use Windows XP’s own Wireless Configuration Utility
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
202-10026-01
iv
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product, unless expressly approved by NETGEAR, Inc., could void the user's right to operate
the equipment.
Export Restrictions
This product or software contains encryption code which may not be exported or transferred from the US or
Canada
without an approved US Department of Commerce export license.
Europe - EU Declaration of Conformity
This product is certified for Switzerland and all EU countries. Marking by the above symbol indicates compliance with
the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). This equipment meets the
following conformance standards: EN300 328, EN301 489-17, EN60950
Requirements For Operation in the European Community
Countries of Operation and Conditions of Use in the European Community
The user should run the client utility program provided with this product to check the current channel of operation and
confirm that the device is operating in conformance with the spectrum usage rules for European Community countries as
described in this section.
This device is intended to be operated in all countries of the European Community.
Operation Using 2.4 GHz Channels in France
The following radio channel usage limitations apply in France.
The radio spectrum regulator in France, Autorité de regulation des telecommunications (ART), enforces the following
rules with respect to use of 2.4GHz spectrum in various locations in France. Please check ART's web site for latest
This
device is a 2.4 GHz low power RF device intended for
home and office use in EU and EFTA member states. In some
EU / EFTA member states some restrictions may apply.
Please contact local spectrum management authorities for
further
details before putting this device into operation.
FOR HOME OR OFFICE USE
Tested to Comply
with
FCC Standards
N E TG E A R WG111v2 54 M bps W ireless USB 2.0 A d apter
PY305400026
Note: This equipment marketed in USA is restricted by firmware to only operate on 2.4 GHz channel 1-11.