User's Manual
Table Of Contents
- Reference Manual for the 54 Mbps Wall-Plugged Router WGX102
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Connecting the Router to the Internet
- Prepare to Install Your Wireless Router
- First, Connect a Wall-Plugged Ethernet Bridge XE102
- Connect the Wireless Router to the Internet
- Now, Set Up a Computer for Wireless Connectivity
- Troubleshooting Tips
- Overview of How to Access the Wireless Router
- How to Manually Configure Your Internet Connection
- Using the Smart Setup Wizard
- NETGEAR Product Registration, Support, and Documentation
- Chapter 4 Wireless Configuration
- Chapter 5 Content Filtering
- Chapter 6 Maintenance
- Chapter 7 Advanced Configuration of the Router
- Chapter 8 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- What You Need To Use a Router with a Broadband Modem
- Preparing Your Computers for TCP/IP Networking
- Configuring Windows 95, 98, and Me for TCP/IP Networking
- Configuring Windows NT4, 2000 or XP for IP Networking
- Configuring the Macintosh for TCP/IP Networking
- Verifying the Readiness of Your Internet Account
- Restarting the Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the 54 Mbps Wall-Plugged Router WGX102
4-12 Wireless Configuration
July 2004 202-10036-01
1.
Log in to the WGX102 firewall at its default LAN address of http://www.routerlogin.net with
its default user name of admin and default password of password, or using whatever LAN
address and password you have set up.
2. Click Advanced Wireless Setup in the main menu of the WGX102 firewall.
3. From the Wireless Settings menu, click Setup Access List to display the Wireless Access
menu shown below.
Figure 4-7: Wireless Card Access List Setup
4.
Click Add to add a wireless device to the wireless access control list. The Available Wireless
Cards list displays.
Note: When configuring the firewall from a wireless computer whose MAC address is
not in the Trusted PC list, if you select Turn Access Control On, you will lose your
wireless connection when you click on Apply. You must then access the wireless router
from a wired computer or from a wireless computer which is on the access control list to
make any further changes.