User's Guide
Table Of Contents
- Chapter 1 About This Manual
- Chapter 2 Basic Setup
- Chapter 3 Network Connections and Wireless Security
- Understanding the Smart Wizard
- Finding a Network
- Profiles
- Setting up a Profile to Connect to an Access Point or Router
- Setting up a Computer-to-Computer (Ad Hoc) Profile
- Wireless Security
- Wireless Network Name (SSID) and Security Settings
- Setting up WEP Encryption Security
- Setting up WPA2-PSK Security
- Setting up WPA-PSK Security
- Networks Page
- Statistics Page
- About Page
- Chapter 4 Troubleshooting
- Troubleshooting Tips
- Frequently Asked Questions
- The Smart Wizard keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to use the wireless configuration utility that comes with Windows XP
- Did the Wireless Adapter receive a valid IP address from the Wireless Router/AP?
- I cannot connect to the AP that I want from the Networks browser list.
- The Wireless Adapter is not getting an IP address
- Why do I see no more than 54 Mbps on the status bar?
- Why do I see two Wireless Adapter icons in the System Tray?
- Appendix A Default Configuration Settings and Technical Specifications
- Appendix B Related Documents
NETGEAR RangeMax NEXT Wireless Notebook Adapter WN511B User Manual
22
v1.1, April 2006
b. Use the icon to open the Smart Wizard. The Settings tab page opens.
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WPA2-PSK [AES].
For more information about WPA2-PSK security, see the Web link to “Wireless
Communications:” in Appendix B.
3. Save your settings in a Profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard.
Setting up WPA-PSK Security
Follow the steps below to configure WPA-PSK Security.
1. Run the Wireless Adapter Smart Wizard.
a. Make sure the software is installed and the Wireless Adapter is fully inserted in a Cardbus
slot in your computer.
Figure 3-8
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.