User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
Installation and Configuration 2-7
v1.0, June 2008
– Default Gateway. Enter the IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the wireless
access point is connected.
– Primary DNS Server. The WN802Tv2 uses this IP address as the primary Domain Name
server used by stations on your LAN.
– Secondary DNS Servers. The WN802Tv2 uses this IP address as the secondary Domain
Name Server used by stations on your LAN.
3. Click Apply to save your Basic IP settings.
Note: If you change the default subnet of the LAN IP address, you will be
disconnected from the NETGEAR Wireless-N Access Point user interface. To
reconnect, reconfigure your computer with a static IP address within the new
LAN IP subnet.
Configuring Basic Wireless Settings
The following section describes how to configure the basic wireless settings for the 802.11b,
802.11bg and 802.11ng modes.
To configure the NETGEAR Wireless-N Access Point wireless settings of your wireless access
point:
1. From the main menu under Configuration, select Wireless.The Wireless Settings screen
displays as shown in
Figure 2-5.